SparkFun MiniGen - Pro Mini Signal Generator Shield

2 reviews
5.00 out of 5

$46.12

Part Number: SF-BOB-11420

This is the SparkFun MiniGen Signal Generator, a small shield for the Arduino Pro Mini that is capable of generating sine, square, or triangle waves at up to 3MHz, and approximately 1Vp-p. Though the MiniGen is technically a shield it can, in fact, operate as a stand-alone board capable of the the same functionality as it would if it were placed on top of a Pro Mini.

The MiniGen offers two out put sources for you to utilize: a 2-pin 0.1" spaced header and a u.FL connector. The output is at a DC offset of Vcc/2, however neither the offset nor the amplitude can be varied. By default, the MiniGen ships configured with a 3.3V regulator enabled and should only be used with 3.3V signals (or 3.3V Pro Minis if you are using this as a shield) unless the jumper on the back is soldered over to bypass the regulator for 5V use.

Features:

  • 10-bit DAC for good accuracy
  • 2 frequency registers
  • 2 phase registers
  • SPI Interface Driven at 40MHz
  • Operating Voltage: 3.3V (5V when jumper is soldered)

Documents:

What shipping methods do we have?

At Arduino Australia, we ship via Australia Post. We provide two shipping methods:

  • Australia Post Express Post (overnight to metro areas): $9.40 AUD
  • Australia Post Regular Post (3-7 business days): $7.20 AUD

Where is our warehouse?

How can I track my order from Arduino Australia?

  • When your order ships from Arduino Australia, a shipping confirmation email with a tracking number is sent to you.
  • Shipments can be then tracked on Australia Post's website.


Add a review